Hyundai Getz>> Steering>> Steering column and steering shaft
Cars without the electroamplifier of a steering

Fig. 5.11. A steering column and a steering shaft without the mechanism of adjustment of provision of a steering wheel: 1–bottom shaft; 2–dashboard beam; 3–bolts of fastening of an arm of a steering shaft;
4–top facing casing of a steering column; 5–block of podrulevy switches; 6–nut of fastening of a steering wheel; 7–bottom facing casing of a steering column; 8–anti-theft device; 9–bottom facing of the dashboard; 10-steering shaft; 11-steering mechanism


Fig. 5.12. A steering column and a steering shaft with the mechanism of adjustment of provision of a steering wheel: 1–bottom shaft; 2–dashboard beam;
3–bolts of fastening of an arm of a steering shaft; 4–top facing casing of a steering column; 5–block of podrulevy switches; 6–nut of fastening of a steering wheel; 7–bottom facing casing of a steering column; 8–provision of blocking of a clamp; 9–handle of a clamp of blocking of provision of a steering wheel; 10-provision of an unblocking of a clamp; 11-bottom facing of the dashboard; 12-steering shaft; 13-steering mechanism


The steering column and steering shaft without the mechanism of adjustment of provision of a steering wheel are shown on fig. 5.11 , with the mechanism of adjustment of provision of a steering wheel – on fig. 5.12 .

Fig. 5.13. A steering column and a steering shaft of cars with the electroamplifier of a steering (rear view): 1–facing of the switch of a sound signal (module of a safety cushion of the driver); 2–steering wheel; 3–electric motor; 4–electronic control unit


Fig. 5.14. A steering column and a steering shaft of cars with the electroamplifier of a steering (side view): 1–bottom shaft; 2–electronic control unit; 3–dashboard beam; 4–bolts of fastening of an arm of a steering shaft; 5–top facing casing of a steering column; 6–block of podrulevy switches; 7–nut of fastening of a steering wheel; 8–bottom facing casing of a steering column; 9–provision of blocking of a clamp; 10-handle of a clamp of blocking of provision of a steering wheel; 11-provision of an unblocking of a clamp; 12-bottom facing of the dashboard; 13-steering shaft; 14-steering mechanism


The steering column and steering shaft of the cars equipped with the electroamplifier of a steering, are shown on fig. 5.13 and 5.14 .
Removal
Disconnect a "minus" wire («–») from the storage battery.

Fig. 5.15. Bolts of fastening of the module of a safety cushion of the driver


Remove the module of a safety cushion of the driver, having unscrewed the bolts of fastening shown by shooters on fig. 5.15 .

       NOTE
On the car without a safety cushion remove facing of the switch of a sound signal.

Fig. 5.16. Nut of fastening of a steering wheel


Unscrew a nut of fastening of a steering wheel (fig. 5.16) .

Fig. 5.17. Removal of a steering wheel from a shaft by means of a stripper


Combine labels on a shaft of a steering and a steering wheel. Remove a steering wheel from a shaft by means of a stripper (fig. 5.17) .

       NOTE
Do not remove a steering wheel in hammer blows – it is so possible to damage a steering shaft.

Fig. 5.18. Screws of fastening of a facing casing of a steering column


Remove a facing casing of a steering column, having unscrewed three screws shown by shooters on fig. 5.18 .
Separate contact sockets of a contact disk of the module of a safety cushion and the block of podrulevy switches.

Fig. 5.19. Removal of the block of podrulevy switches


Remove the block of podrulevy switches, having pressed it in the places shown by shooters on fig. 5.19 .

Fig. 5.20. Removal of the bottom facing of the dashboard


Remove the bottom facing of the dashboard, having unscrewed two bolts of fastening (fig. 5.20) .

Fig. 5.21. Bolts of fastening of an arm of a shaft of a steering


Unscrew four bolts of fastening of an arm of a shaft of a steering (fig. 5.21) .

Fig. 5.22. A bolt of fastening of the kardanny hinge to a driving gear wheel of the steering mechanism


Unscrew a bolt of fastening of the kardanny hinge to a driving gear wheel of the steering mechanism (fig. 5.22) .

Fig. 5.23. Removal of a steering shaft assembled


Remove a steering shaft assembled (fig. 5.23) .
Check of a technical condition
Check a steering shaft on existence of damages and deformation.
Check shaft connections on existence of gaps, damages and on smoothness of moving.
Check the ball bearing on existence of wear and damages.
Analysis and assembly
In need of removal of the anti-theft device make a chisel a groove under shlitsa of a screw-driver on heads of special bolts of fastening.

Fig. 5.24. Otvorachivaniye of bolts of fastening of the anti-theft device


Screw-driver unscrew two special bolts of fastening (fig. 5.24) .
Remove the anti-theft device from a steering shaft.

Fig. 5.25. A special bolt of fastening of the anti-theft device to a steering shaft


At installation of the anti-theft device acquire new special bolts of fastening of the device to a steering shaft (fig. 5.25) .
Tighten special bolts a wrench before cutting of heads.

Fig. 5.26. Bolts of fastening of the bottom shaft to knot of a steering column


Unscrew fastening bolts (12 mm) bottom shaft to knot of a steering column and the top shaft (fig. 5.26) .

Fig. 5.27. A detachment of the bottom shaft from knot of a steering column


Disconnect the bottom shaft from knot of a steering column and the top shaft of a steering (fig. 5.27) .
Assembly carry out as it should be, the return to dismantling.

Cars with the electroamplifier of a steering

Fig. 5.28. Contact socket of the electroamplifier of a steering


Separate the contact socket of the electroamplifier of a steering (fig. 5.28) .

Fig. 5.29. Screws of fastening of the electroamplifier of a steering


Remove knot of the electroamplifier, having unscrewed three screws of fastening (fig. 5.29) .
Assembly carry out as it should be, the return to dismantling.
Installation
Establish into place a shaft of a steering and "acquire" four bolts of fastening.
Screw a bolt of fastening of the kardanny hinge of a shaft to a driving gear wheel of the steering mechanism, located behind a brake pedal.
Tighten four "nazhivlenny" bolts of fastening of a shaft of a steering.
Establish the bottom facing of the dashboard and screw two bolts of fastening.
Establish on a steering column to a zashchelkivaniye the block of podrulevy switches.
Establish a contact disk of the module of a safety cushion and connect the socket of the block of podrulevy switches.
Establish the top and bottom facing casings of a steering column and screw fastening screws.
Establish a steering wheel and tighten a fastening nut.
Establish the module of a safety cushion and wrap three bolts of fastening.
Attach a "minus" wire («–») to the storage battery.